Tutorials

6.7L 10-12' Cummins EGR Delete [PRO-87110EGRD]

Posted by Branden Walter on

6.7L 10-12' Cummins EGR Delete [PRO-87110EGRD]

Step 1: Disconnect batteries  Step 2: Drain engine coolant. Step 3: Remove the plastic engine cover that is held in place by four8mm bolts. Note: The dipstick must be removed in order to remove the plastic engine cover. Step 4: Using an 11mm socket loosen the two V-band clamps. Remove the 10mm bolt in the center of the tube and disconnect the sensor plug. The EGR crossover tube can now be removed. Step 5: Remove the electrical connector on the EGR valve. Note: Some electrical connectors may have a locking tab. In order to remove these   connectors the tab...

Read more →

How to // Keyless FOB Reprogramming

Posted by Branden Walter on

How to // Keyless FOB Reprogramming

Here is a quick HowTo on programming your own keyless entry: 1) Turn ignition to OFF. 2) Locate the Data Link Connector, its a black 16 pin connecter that is under the driver's side dash, right where your right knee would be. You have to look up into the dash from below to see it. 3) Ground pin 1 of the Data Link Connector by taking a wire or paper clip and running it from pin 1 to pin 4. Pin 4 is ground so you can just short pin 1 to 4 and it will be grounded. Grounding pin...

Read more →

How to Install a CTS2 Insight Display

Posted by Branden Walter on

How to Install a CTS2 Insight Display

STEP 1 - Plug the HDMI connector into the HDMI receptacle located on the back side of the display. STEP 2 - Align the Dual Tabs on the Mount with the mount receiver on the back side of the display, then slide it into place. STEP 3 - Adjust the viewing angle using the adjustment nut on the mount’s swivel head. STEP 4 - Pull any extra cable back behind the pillar and dash. (Re-install any panels removed during the Cable Installation.)   Display Setup: STEP 1 - Turn the vehicle to the ON or RUN key position. STEP 2 - Select one of the three...

Read more →

How to install a Bullydog GT tuner

Posted by Branden Walter on

How to install a Bullydog GT tuner

  Installation Steps by Steps Since they deliver high levels of performance, a lot of people think that installing performance chips must difficult. But installation is actually one of the easiest of all performance upgrades, just plug into the OBD II port in your truck. Once you’ve accomplished this, you’re basically done. Here’s a quick installation overview: Remove tuner from box Plug into vehicle’s OBD II port Follow tuner prompts Installation Tips It really is that easy. Even if you’re installing other brand diesel or gas programmers, like an Edge tuner, installation is the same—simply plug it into this easy-to-access...

Read more →

Wheel spacers: a useful addition or and unnecessary modification?

Posted by Branden Walter on

Wheel spacers: a useful addition or and unnecessary modification?

With truck stance modification becoming ever more prevalent, it is no doubt that the controversial topic of wheel spacers will get brought up. Wheel spacers are a hot topic when it comes to adding a more aggressive look to your truck by spacing out the area between the rotor and the wheel, just like any other modification to your truck it comes with its pros and cons. We will be exploring the reasons many people chose this form of mod for their trucks Firstly, wheel spacers come in many different sizes and widths. Wheel spacers offset the width of your truck...

Read more →